Exceptionally heavy duty, trowel applied cementitious urethane mortar (3/8″-1/2″ / 0.95-0.50cm). Contains Polygiene® which has antimicrobial properties that protect it from degradation caused by microorganisms. Demonstrates excellent resistance to mechanical damage, heavy machinery, thermal shock, and chemical attack.
Technical Data Sheet | System Information Sheet | Safety Data Sheet [Part A] | Safety Data Sheet [Part B] | Safety Data Sheet [Filler]
Features:
- Iron filled for ultra durability
- Unaffected by MVT (moisture vapor transmission)
- High abrasion resistance
- Resistant to thermal shock
- Withstands high mechanical stress
- Capable of withstanding stress from heavy machinery
- Easy to clean and sterilize surface
- Resistant to steam cleaning
- Positive slip resistance
- May be applied to “green” concrete
- Ultra low VOC/odor
- Suitable for use in USDA facilities
Color:
- Stocked Colors: Red (Q501), Mid Gray (Q703), Cream (Q202), Dark Gray (Q704), Tan (Q204), Khaki (Q205), Green (Q302), and Safety Yellow (Q603), and Black (Q900).
- General wear on Sky Blue and Safety Yellow may be more visible. Shock-Crete is not color fast and may change color over time (exhibits a yellowing effect). Color change depends on the UV light and heat levels present as such the rate of change cannot be predicted. This is more noticeable in light colors and grays, but does not compromise the product’s chemical resistance or physical characteristics.
Finish:
- Matte
Primer:
- Does not normally require a primer.
Recommended Thickness:
- 3/8-1/2” (0.95-1.27 cm)
Typical Uses:
- Ideal for situations where extra protection against wear and abrasion are needed.
Coverage Rate:
- 14 ft²/unit at 3/8″ per 62 lb unit (1.3 m²/unit at 0.95cm per 28 kg unit)
- 10 ft²/unit at 1/2″ per 62 lb unit (0.9 m²/unit at 1.27cm per 28 kg unit)
VOC Values:
- As supplied: 0.04 lbs/gal (5 g/L)
Dry Temp. Resistance:
- Continuous: 220°F (104°C)
- Non-Continuous: 250°F (121°C)
Limitations:
- Shock-Crete IF may change color over time depending on exposure to UV light and heat. This does not compromise the product’s chemical resistance or physical characteristics.